|
|
|
|
| Category:
Snowmobiling
/
Snowmobile Parts
|
 |
| Start Price: |
USD 19.50 |
Click Here
to See More
|
| Current Price: |
USD 19.50 |
| Reserve Price: |
- |
| Time Left: |
- |
| Bid Count: |
0 |
| Buy It Now Price: |
- |
| Start Time: |
8/30/2008 |
| End Time: |
9/6/2008 |
| Location: |
Hutchinson, MN |
|
This is a brand new CNC machined flywheel puller made out of 1018 steel for Arctic Cat ZR ZL 440, 580 & 600snowmobiles. Will work on ZRT's and Thundercats with slight modification and different bolts. (M8's rather than M6's) As far as possible modification, you may just have to drill the outer 3 holes larger to accomodate larger bolts. These are specifically made for the ZR & ZL twins though so function on other that that is not gauranteed..I have been told that they will work for big bore 800 / 900's by just opening the holes up to 3/8" The bolts are included. These work great, just remove your starter cup, flywheel nut and washers, and screw the puller up tight to flywheel and then just a couple of gentle pops with your air impact wrench and your flywheel is off in about 5 seconds. I have never damaged anything using my puller, but if your flywheel is stubborn you will want to put a protection nut or something on the threads of your crank just to make sure you do not damage any threads. This is not an Arctic Cat made puller, but my own designed and machined puller. Shipping will be a flat $7.50 anywhere in the United States. If being shipped out of the USA, International rates will apply and you should contact me before paying, for an accurate shipping rate. Thanks for looking
Place a Bid!
|
HOME
|
|